
- :86-371-86151827 86151527
- :0086-371-86011881
- :[email protected]
- :bebonchina
Machining Allowance on Round Bar: How Much Stock to Leave
Machining allowance is the money question in round bar procurement: leave too little and the black surface or decarburized layer survives into the finished shaft; leave too much and every pass costs machine hours and carbide. The right figure depends on how the bar was made, because each delivery condition carries a different depth of surface defect.
Hot rolled bar: allowance for scale and decarb
Hot rolled round bar carries mill scale, a decarburized skin of roughly 0.3–0.5 mm per side on small diameters and more on large ones, plus diameter tolerance of about ±0.5 mm depending on standard. A practical starting point: total stock on diameter of 4–6 mm for bars up to 80 mm, and 6–10 mm above that, before any straightness correction. Forged bar needs more — its surface condition and possible subsurface flaws justify generous allowance on large sections.
Cold drawn bar: just clean up
Cold drawn bar is sized to h9/h11 with a smooth bright surface and no scale. It needs no roughing pass in the conventional sense — one finishing cut of 0.3–0.5 mm on the radius usually reaches size. The catch is residual stress: heavy cuts on cold drawn bar can distort it, so for long slender parts, rough-turn lightly on both ends first or specify stress-relieved material.
Fit the allowance to the process chain
Plan the chain before ordering: if the part is peeled, centerless ground and then turned, the bar supplier can deliver peeled or ground bar with the allowance already removed — buying hot rolled and removing 5 mm of scale in-house is often more expensive than buying the right starting condition. Conversely, ordering precision ground bar for a part that will be fully machined anyway is wasted money.
What to state on the order
Specify diameter with the tolerance class, delivery condition (hot rolled, peeled, cold drawn, ground), straightness limit, and cut lengths rather than random mill lengths — cut-to-length bars with facing on both ends remove most of the first operation. Keep the allowance conversation with the bar supplier, not just the machine shop: the two decisions are linked, and agreeing them together is what actually saves cost.

